RV, Marine, & Other Bulbs

IMPORTANT NOTES: Please Read Before Ordering Car Bulbs

BA15 Dual & Single Contact LED Cluster Bulbs

15mm Bayonet base bulb for 6, 12, and 24 Volt Applications
1142 - Dual Contact and Single Intensity - 12 & 24 Volt
1157 - Dual Contact and Dual Intensity - 6 & 24 Volt
1156 - Single Contact and Single Intensity - 6 & 12 Volt
See Car Bulbs for 12 Volt 1156 & 1157 bulbs
We also offer empty BA15 Bases and Wired Sockets

PCB Series LED Lamps

This unique LED Lamp is offered exclusively by Super Bright LEDs Inc. Applications for tight overhead lighting where other LED bulbs will not work effectively. The LED board can be affixed with double-sided foam tape or, due to their extremely low heat generation, the LED board can be simply laid on the diffuser lens.
Designed for overhead lighting in boats, campers, box trucks, etc.
We also offer empty BA15 Bases and Wired Sockets

close(x)
Important Note :
PCB-WHP9 Lamps
- Base cannot be clipped off of PCB-WHP9 unit. Driver circuit is inside of base and is required.
- Non-Polarized
All other PCB Lamps
- Base can be clipped off of PCB units with 5mm LEDs for direct wiring, but it does void the warranty.
- Polarized: if lamp does not light you MUST either swap power wires on your socket or on the lamp.

Double-Sided Foam Tape - 3M VHB

Closed-Cell Acrylic Foam Tape 3M VHB tape has high performance adhesive on both sides.
Used for attaching Light Bars and other products to a wide variaty of surfaces.
Measures 1.25 x 0.625 inches, 0.088 thick

WLED Miniature Wedge Base Bulbs

T3-1/4 (#194/168) miniature wedge base bulbs found in various low voltage applications
Built in current limiting resistor and diode to protect the LED from reversed polarity installation
Replaces: 194, 158, 168, 12256, 12961

Edison Screw Base Bulbs

12 Volt DC E27/E26 Medium Screw Base bulb for
Low Voltage off-grid power systems
Wide voltage range T10 flashlight type bulb
6VDC and 12VDC E12 base bulb
Candelabra - Intermediate - Medium Screw bases

Candelabra Base Exit Sign bulb

20-LED or 33-LED Candelabra base bulb with RED LEDs 145VAC Operation Designed for Exit Sign Illumination
Clear Lens 12mm dia. Edison screw base Bulb measures 5.21" OAL x 1" dia
33-LED version illuminates Exit Sign brighter than standard 15 Watt incandescent bulb
No harmful IR rays that deteriorate internal plastic housings of Exit Signs
Consumes just 0.4~0.7 Watts of power
30,000 hrs lifetime

G4 Lamps with High Power SMD LEDs

GZ4 base bulbs with High Power Cool White or Warm White LEDs Built-in Buck Driver allows wide operating voltage range of 8~30VDC (8~14VAC)
12 Volt AC or DC operation
0.9~1.25 inch diameter
Fits standard GZ4 base - 1mm pins with 4mm spacing